What Continuous Clicking After Lighting means on your Dacor rangetop (dacor rangetop continuous clicking sound)
This is a symptom page, not an error code — rangetops carry no code display, so this behavior is described here in plain terms instead. Continuous clicking after the burner has already lit means the spark module has not received the signal to stop, usually because moisture or a stray gap is still triggering the electrode even though gas is now burning normally. It is annoying rather than dangerous in most cases, but it wastes the igniter’s working life over time.
Symptoms
A Dacor rangetop in this condition usually shows some combination of the following, so match them against your own rangetop before booking.
- The burner lights and holds a normal flame, but the clicking does not stop.
- Clicking is louder or more frequent right after cleaning the cooktop.
- Only one burner station clicks; the rest behave normally once lit.
- The sound fades on its own after a minute of use in some cases.
Common causes
A Dacor rangetop can reach this condition by more than one route, and the cheap causes are worth eliminating on the rangetop before the expensive ones.
- Moisture on the electrode — condensation or cleaning liquid keeps arcing across the gap after ignition.
- Spilled liquid in the burner well — residue under the burner head creates a stray conductive path.
- Bent electrode — a knock during cleaning shifts the gap distance so the spark keeps firing.
- Stuck igniter switch inside the knob — the knob’s internal contact does not fully release when turned to a cook setting.
Troubleshooting steps you can try
Each check below is one an owner can make on a rangetop without tools, and each rules something out about Continuous Clicking After Lighting before a technician is called to the rangetop.
- Turn off the burner and let it cool completely before touching any part.
- Wipe the burner well and the electrode dry with a lint-free cloth.
- Check that the electrode has not been bent toward or away from the burner cap.
- Turn the knob fully to off and back to a low setting to confirm the click stops with the flame lit.
- Book a technician if the clicking persists after the components are clean and dry, since a stuck switch cannot be fixed by cleaning alone.
Parts a technician may replace
Expect the spark ignition module, igniter electrode, burner cap, and wiring harness to be checked on your Dacor rangetop. Replacing more of a rangetop than the problem requires is how a small rangetop repair becomes an expensive one, so the failed part is confirmed first.
When to call a technician
A technician checks the knob switch contact and electrode gap with the burner disassembled, replacing whichever part is not resetting correctly. Low severity means the rangetop can wait, but a recurring Continuous Clicking After Lighting on a rangetop should be diagnosed rather than ignored. Your rangetop is handled by an independent workshop with genuine OEM or trusted-supplier parts and a 30-day labor warranty.
Related help and Dacor resources
If the checks above did not clear the Continuous Clicking After Lighting condition, book a technician for the rangetop. Our rangetop problem index covers the neighboring problems, and www.dacor.com carries the rangetop spec.
