- Combines venting hood, convection, and microwave in one unit
- Electric convection element
- Silver Stainless finish
The Dacor PCOR30S is a current 30-inch over-the-range convection microwave hood. The Dacor PCOR30S is a 30-inch over-the-range convection microwave hood, in Silver Stainless. The PCOR30S is part of what Dacor and the press call the Modernist generation — the umbrella name for Dacor's current, flagship SmartThings-connected lineup, of which Contemporary, Transitional and Professional are the specific finish/hardware styles. What a technician actually finds on the PCOR30S matches its listed features: Combines venting hood, convection, and microwave in one unit; Electric convection element; Silver Stainless finish. Reading the PCOR30S's model number is straightforward for the part that is documented: the number right after the letter prefix (30) is the nominal size in inches, a pattern that holds across Dacor's whole current lineup — there is no official Dacor-published key to every remaining letter position, so treat anything beyond size and hinge/finish letters as unconfirmed. No primary Dacor manual for this appliance type documents a confirmed rating-plate location for the PCOR30S, so the honest instruction is to check the door edge, the door frame, or an interior wall of the cabinet and photograph whatever plate is found there. The components that fail most on a built-in microwave like the PCOR30S are the magnetron itself, the door interlock switches, and the turntable motor. What usually goes wrong on a microwave built like the PCOR30S is a magnetron that no longer produces heat, a worn door-interlock switch, or a control keypad membrane that stops responding. The recurring failure points on the PCOR30S are the high-voltage diode or capacitor in the magnetron circuit, the door-interlock switches, and the turntable drive motor. Diagnosing the PCOR30S means checking the door-interlock switches first, since a no-heat complaint on a unit that otherwise runs normally often traces there before the magnetron is ever tested. Dacor publishes no error codes at all for the PCOR30S's appliance type — a verified absence read directly out of the official manuals, not a gap in this site's research. The PCOR30S is diagnosed by symptom instead — what it is doing, not a code it is displaying. The manual for Dacor's over-the-range convection microwave hood uses only the single generic word ERROR on its display for several unrelated problems; the F0/F1 tables some sites attribute to a microwave like the PCOR30S are word-for-word copies of the wall-oven codes relabeled, not a genuine microwave document. Since Samsung completed its acquisition of Dacor in September 2016, Dacor has kept its own brand and dealer network while sharing engineering with its parent, and the PCOR30S is part of that shared engineering. The PCOR30S is a product of a brand with real history: Pasadena, California, 1965, three generations of family ownership, and then a September 2016 acquisition that made Dacor a wholly owned Samsung Electronics America subsidiary while it kept its own name and dealer network. Getting the PCOR30S repaired correctly starts with correctly identifying it — model number, generation, and platform — rather than assuming a code, a part, or a symptom seen on a different Dacor appliance carries over automatically.
A PCOR30S shows one undifferentiated word — ERROR — for several unrelated conditions. There is no Dacor code table for a microwave, and the F0 and F1 codes attributed to one online are the wall-oven table with the label swapped. See the repair guides for the diagnosis, the model directory for the other units in the range, and www.dacor.com for the factory specification.
