- Built-in espresso/coffee system
- Built-in bean grinder
- Direct plumbed water connection
- Steam wand and hot water tap
The Dacor CM24P-1 is a discontinued / legacy 24-inch built-in plumbed automatic coffee system — no longer in production, but we still service it. The Dacor CM24P-1 is a 24-inch built-in plumbed automatic coffee system. Dacor did not market the CM24P-1's platform under one of its named design collections in the sources behind this page, so no collection claim is made for it here. Day to day, what defines the CM24P-1 is Built-in espresso/coffee system; Built-in bean grinder; Direct plumbed water connection; Steam wand and hot water tap. Reading the CM24P-1's model number is straightforward for the part that is documented: the number right after the letter prefix (24) is the nominal size in inches, a pattern that holds across Dacor's whole current lineup — there is no official Dacor-published key to every remaining letter position, so treat anything beyond size and hinge/finish letters as unconfirmed. No primary Dacor manual for this appliance type documents a confirmed rating-plate location for the CM24P-1, so the honest instruction is to check the door edge, the door frame, or an interior wall of the cabinet and photograph whatever plate is found there. The parts that go first on a built-in coffee system like the CM24P-1 are the boiler/brew-group heating element, the flow meter that measures water passing through, and the internal grinder motor. What typically fails on a platform like the CM24P-1 is the brew-group heater, a flow meter that has stopped reporting water flow accurately, or the steam-wand solenoid valve. On a built-in coffee machine like the CM24P-1, descaling neglect is the single biggest contributor to boiler and flow-meter failures, ahead of any single component simply wearing out. Diagnosing the CM24P-1 starts with checking the flow meter and the brew-group heater directly, since descaling neglect affects both and mimics a bigger electrical problem. The CM24P-1 never shows an alphanumeric error code at all — Dacor's coffee system communicates in full-sentence messages instead, confirmed directly from the Automatic Coffee System Use and Care Manual: "Machine Ready - Drawer Out," "System Off - Front Panel Open," "Please Milk Clean," "Clean Group," a named "[Subsystem] Group Error," "Timeout Filling Up Broiler," "Flow Meter Error," "Error - Coffee Temperature" / "Error - Steam Temperature," and "Too Much Coffee." Some of these are routine reminders rather than problems — the milk-clean and group-clean messages appear on a schedule, not because anything has broken. As a Legacy Dacor product, the CM24P-1 predates the September 2016 Samsung acquisition and runs on Dacor's own proprietary control architecture rather than anything Samsung-derived. The CM24P-1 carries the history of the whole brand behind it: Dacor was founded in Pasadena, California in 1965 by Stanley Joseph, stayed family-owned for three generations, and became a wholly owned Samsung Electronics America subsidiary when the acquisition closed in September 2016. A repair on the CM24P-1 goes faster when the exact model and, if available, the serial number are confirmed before parts are ordered, since Dacor's platforms diverge enough by generation that a close-but-wrong SKU can mean a part that does not fit.
A CM24P-1 speaks in full sentences on its display, never in codes — and it is worth knowing early that Dacor no longer sells a coffee system at all. See the repair guides for the diagnosis, the model directory for the other units in the range, and www.dacor.com for the factory specification.
