What Grease Filter Light Stuck means on your Dacor range hood (dacor range hood filter light stuck on)
Your range hood will never display a code for this, because Dacor publishes none — this is the symptom itself. On hoods with a filter-clean reminder light, the indicator runs on a timer or cycle count rather than sensing filter condition directly, so it needs a deliberate reset after cleaning — it does not turn off automatically just because the filter is clean again.
Symptoms
Use these signs to confirm the range hood really has this problem rather than one of the several range hood problems that resemble it.
- The grease filter indicator light stays lit even right after washing or replacing the filters.
- No other problem is present; fan and lights work normally.
- The light has been on for what feels like an unusually long time before this cleaning.
- Pressing the fan buttons does not affect the indicator light at all.
Common causes
Work down the causes below in the order given: on a Dacor range hood the first two account for most of these calls before a range hood technician is needed.
- Reminder not manually reset after cleaning — most models require holding a specific button for several seconds after cleaning to clear the timer.
- Reset held for too short a time — some resets need a longer press than expected to register.
- Indicator circuit failure — rare, but a light that will not clear even after a correct reset attempt may indicate a control failure.
Troubleshooting steps you can try
Start at the top and work down your range hood: the checks get progressively less likely, and the point at which they stop being safe for a range hood is marked.
- Check the use and care manual for the specific reset sequence for the filter light on your model.
- Hold the designated reset button for the full time specified, since a short press is a common reason the reset does not register.
- Confirm the filters are actually reinstalled correctly before resetting, since a missing filter can also affect the indicator on some models.
- Cycle power at the breaker if the manual reset sequence does not clear the light.
- Book a technician if the indicator will not clear after a correct reset and a power cycle.
Parts a technician may replace
On a range hood in this condition the likely candidates are the control board, reset button, and indicator light. Each is tested on the range hood before it is replaced, and the part is matched to your range hood from its model and serial number.
When to call a technician
A technician checks the control board’s reset input only after confirming the correct reset sequence was used and did not work. There is no urgency at Low severity, yet a range hood that repeats Grease Filter Light Stuck after these checks deserves a technician’s eyes. We hold no affiliation with the manufacturer of your range hood; the parts are genuine and the labor is warranted for 30 days.
Related help and Dacor resources
If the checks above did not clear the Grease Filter Light Stuck condition, book a technician for the range hood. Our range hood problem index covers the neighboring problems, and www.dacor.com carries the range hood spec.
