What Broil Element Glows Oven Runs Cold means on your Dacor range (dacor range oven runs cold)
This page covers a symptom of a range rather than an error code, because no such Dacor code exists. — this specific combination, where broil clearly works but bake does not produce real heat, does not reliably trigger any of the F or C codes because the control board may still be sending the correct bake command without confirming actual heat output at the element. This is a genuinely useful pattern to notice: when broil confirms the control board, wiring, and power supply are all basically healthy, the problem narrows almost entirely to the bake element and its relay.
Symptoms
Compare what your Dacor range is actually doing against the list below, since more than one range problem can look like Broil Element Glows Oven Runs Cold at first.
- The broil element glows visibly when broil is selected, confirming it and its circuit work.
- Selecting bake produces no real heat, even though the display shows the set temperature and appears to be running normally.
- Food placed in the oven during a bake cycle does not cook or browns extremely slowly.
- An independent oven thermometer confirms the cavity is staying near room temperature despite a bake cycle running.
- No error code appears on the display despite the clear lack of bake heat.
Common causes
The list below covers what actually causes Broil Element Glows Oven Runs Cold on a range, in the order a technician would eliminate them on a Dacor range.
- Burned-out bake element — the element has failed completely or partially, producing little or no heat despite drawing some power.
- Failed bake relay — the control board is sending the command, but the relay that switches the bake element has failed open.
- Loose bake element wiring — a connection between the control system and the bake element has come loose.
- Blown internal thermal fuse on the bake circuit — a one-time safety fuse specific to the bake element has tripped.
- Sensor miscommunication masking the problem — less commonly, the temperature sensor is reporting a plausible value even though the cavity is not actually heating.
Troubleshooting steps you can try
Run these checks on your Dacor range in the order given, stopping at the first that asks you to open the range up or touch anything electrical.
- Confirm broil clearly works by watching the element glow, which rules out the control board and main power supply as the cause.
- Use an independent oven thermometer placed on a center rack during a bake attempt to confirm the cavity is not actually heating.
- With the oven off and cool, look at the bake element for a visible break, blister, or scorch mark.
- Power-cycle the range at the breaker and try a short bake cycle again to confirm the pattern repeats.
- Avoid repeated full-length bake attempts while troubleshooting, since a failed element will not begin heating no matter how long you wait.
Parts a technician may replace
A technician will work through the bake heating element, bake relay, oven temperature sensor, and control board on your range. Genuine OEM or trusted-supplier parts are matched to the range by model and serial number rather than fitted to a range on spec.
When to call a technician
A working broil element paired with a cold bake cycle points almost directly at the bake element or its relay, and a technician can usually confirm and replace the correct part in one visit. This rates Medium on a range, so take your time — but do not keep clearing Broil Element Glows Oven Runs Cold on the range without finding out why. Nobody here works for Dacor; we are an independent service, and the work we do on your range is warranted for 30 days.
Related help and Dacor resources
Once the Broil Element Glows Oven Runs Cold condition has outlasted the owner-level checks, the range is a service call: book one, or read the other range problem pages. www.dacor.com holds the range data sheet.
